Kiosk
How do I install a rear CSR scanner?
Step-by-step instructions for installing a rear CSR scanner on a Mashgin kiosk.
📋 Overview
Installing a rear CSR scanner takes four steps: verify the parts, plug the USB cable into the correct kiosk port, activate the scanner (especially important if ID scanning is enabled at the location), and test scan an item.
🔧 Installation Steps
Step 1. Unbox the scanner and verify parts
- Take the scanner out of its box and packaging.
- Inspect the scanner for any physical damage before installing.
Step 2. Connect the USB cable
Connect the USB cable to the third USB port below the ethernet port on the back of the kiosk.
Step 3. Activate the scanner
If the location uses ID scanning, follow the activation procedure to scan the configuration barcodes in order.
Most scanners will come activated; go ahead and test before attempting to activate.
Step 4. Test scan
Confirm the scanner is working by scanning any item with a barcode.
💡 Tips
- Listen for the reconnect beep when plugging in the USB cable — it confirms the kiosk detected the scanner.
- If the scanner powers on but won't read barcodes, it likely needs to be activated (Step 3).
🔗 Relevant Articles
Need help? Contact support at 📧 help@mashgin.com or call (855) 475-0889